In order to optimize your browsing experience we uses cookies. You agree to the usage of cookies when you browsing this site.
For more information regarding cookies and the processing of your personal data please read our Privacy Policy.
SUPPORT
Listen to Your Voices and Let Us Know Your Needs
Back
Gowin MIPI Byte-to-Pixel Converter
Gowin MIPI Byte-to-Pixel Converter IP is used to convert the parallel payload data from 1~4 lanes output by the MIPI DSI/CSI-2 RX IP into pixel format data. Additionally, it utilizes the packet header information to generate corresponding video synchronization signals such as VS (Vertical Sync), HS (Horizontal Sync), and DE (Data Enable).
- Complies with MIPI DSI V1.1 and MIPI CSI-2 V1.1 standards
- Supports RX lanes: 1, 2, 3, or 4
- Supports MIPI RX D-PHY with 1:8 and 1:16 modes
- Supports output of one or two pixels per clock, and some formats support output of four pixels
- Supports three video modes as defined in the MIPI DSI standard
- Non-Burst Mode with Sync. Pulses
- Non-Burst Mode with Sync. Events
- Burst Mode - The following video formats specified in the MIPI DSI Spec are supported:
- RGB-888
- RGB-666
- RGB-666, loosely packed
- RGB-565
- YCbCr-422_24-bit
- YCbCr-422_16-bit
- YCbCr-422_20-bit, loosely packed
- RGB_30-bit
- RGB_36-bit - The following video formats specified in the MIPI CSI-2 Spec are supported:
- RGB-888
- RGB-666
- RGB-565
- RAW-8
- RAW-10
- RAW-12
- RAW-14
- YUV420 8-bit
- YUV420 8-bit, CSPS
- YUV420 10-bit
- YUV420 10-bit, CSPS
- YUV422 8-bit
- YUV422 10-bit